LED License Plate Lights Seat Leon Ibiza Altea

Seat Leon, Ibiza and Altea LED license plate lights: a clear rear end at night

These Seat LED license plate lights replace the original bulb modules and transform the rear of your car from a yellowish glow to a clean, even white. On a Leon parked under a streetlight or an Ibiza reversing down a dark driveway, the difference is striking: the license plate is clearly visible, and the entire bumper looks more refined. It is one of the few details that costs little and is immediately noticeable, from the very first night out.

The 6000K white of this license plate module on a Leon or Ibiza Cupra

The chosen shade is a super bright 6000K white, deliberately close to that of the LED daytime running lights fitted as standard on recent Seat models. The result: the rear of the vehicle regains a consistent color with the front, where the original W5W bulb tends toward orange and betrays the car's age. On an Ibiza Cupra or Bocanegra, this clean light highlights the bumper's contours and makes the license plate stand out instead of washing it out.

The housing is black, the exact size of the original module (78 x 27 x 22 mm), and fits into the same housing without any play or need for additional spacers. Seen from the outside, nothing protrudes: you only see the result, not the accessory.

Integrated Canbus, 3 W and 12 V: the technology behind this Seat license plate light

Each module features a voltage stabilizer and an integrated decoder. In practical terms, these are error-free LED license plate lights: no resistors to wire up, no extra cable to run, and no message on the dashboard of Seat models equipped with a CAN network. Power consumption drops to 3 W for a significantly higher intensity than the original bulb, which also reduces the load on the rear electrical circuit.

• 6000K white LED license plate light — a clean light that makes the license plate perfectly visible at night
• Error-free Canbus LED module — integrated decoder, no fault light on the instrument panel
• Direct replacement without modification — same dimensions as the original module, no drilling required
• 12 V T10 (W5W / 194) interface — standard connector, 128 mm cable length
• Reduced 3 W power consumption — less load on the alternator, longer lifespan
• Supplied as a pair — both sides replaced at once for a consistent color

Fitting these license plate lights on an Altea XL, Exeo or Leon

Installing the LED license plate lights requires a flat-head screwdriver and no more than fifteen minutes. Gently unclip the original module from the tailgate or bumper, disconnect the connector, position the new module in the same orientation, then push it back until it clicks. Work on both sides one after the other. Once the ignition is turned on, the result is immediately visible. Compatibility stated: Altea (XL / Freetrack models) from 2007 onwards, Exeo and Exeo ST from 2009 onwards, Ibiza (Cupra / Bocanegra / FR) from 2009 onwards, Leon and Leon 4 from 2006 onwards — to be checked according to the version before installation, as the housings evolved during production.

Is an additional decoder needed to prevent a warning light on the dashboard?

No. That is precisely what the integrated decoder version is designed for: the voltage stabilizer in each module simulates the power consumption expected by the control unit. You therefore do not need an external decoder or ballast resistor. If a lighting fault still persists, it will almost always be due to a poorly seated connector or an oxidized bulb holder on a car exposed to moisture — a point to check before suspecting the module.

Your Seat rear LEDs, chosen by car enthusiasts

At Becquet Voiture, lighting is one of the product categories we monitor closely, because a poorly chosen LED license plate bulb is immediately noticeable: a bluish tint, a protruding module, or a warning light. We prefer complete modules to simple bulbs, as they are more stable over time and look much cleaner. Have a question about compatibility with your model year? Our French team will answer it before you place your order.

Give your Seat a clean, bright rear end: order your pair of LED license plate lights today.

Type: LED license plate light module
Brand / Compatible models: Seat Altea XL and Freetrack (2007-), Exeo and Exeo ST (2009-), Ibiza Cupra / Bocanegra / FR (2009-), Leon and Leon 4 (2006-)
Years: Depending on version — to be checked before installation
Light source: White LEDs
Color temperature: 6000 K white
Power: 3 W
Voltage: 12 V DC
Interface type: T10 (W5W / 194)
Decoder: Integrated Canbus, error-free
Housing color: Black
Dimensions: 78 x 27 x 22 mm (L x W x H)
Cable length: 128 mm
Weight: 80 g
Quantity: 1 pair (2 modules)
Installation: Direct replacement, no wiring modification