LED Fog Lights Audi Q7 2006-2009 Pair

LED fog lights for Audi Q7 4L: the complete pair to restore a clear front end

This pair of LED fog lights for the Audi Q7 (model years 2006, 2007, 2008 and 2009) replaces tarnished, cracked or fogged-up original units. You receive the left and right sides, with the LED sources already built-in: no bulbs to buy, no sockets to search for, just clip them into the bumper.

Why replace the original units

• Complete left and right pair: both sides are supplied, ensuring a perfectly matched tint.
• Built-in LED source: instant-on, stable white light, with no gradual warm-up.
• Clear PMMA lens: it stays crystal clear where fifteen-year-old original glass has yellowed.
• Original mounting and connector: same tabs, same plug, no adapter required.
• Reduced power consumption: just a few watts per unit instead of 55 W for a standard H11 halogen bulb.
• Sealed housing: peripheral seal and vent, designed for driving in the rain.

What is a front fog light for

A front fog light emits a wide, very flat beam, positioned low in the bumper. This geometry illuminates the road under the fog layer, rather than cutting through it and reflecting a wall of white light into the driver's eyes. On a 4L Q7, these units also take the brunt of road gravel: replacing them is routine maintenance, not an exceptional repair. A new pair gives the front end a clean look, even during the day.

Technical specifications

Stated compatibility: Audi Q7, model years 2006 to 2009, to be checked before installation by comparing the connector and mounting tabs.
Contents: 2 units, left and right sides.
Source: Built-in LEDs, white light.
Voltage: 12 V DC.
Lens: Clear PMMA.
Housing: Black ABS with sealing gasket.
Condition: 100% new.

Installation and maintenance

Allow 30 to 45 minutes for both sides. Turn the steering wheel fully, spread the wheel arch liner after removing two or three clips, then disconnect and unclip the original unit. Position the new unit, plug in the connector and check that it lights up before closing everything up. Then check the beam alignment against a wall at 5 m: it should shine low and wide, without spilling upwards. Maintenance: clean the lens with car shampoo, never use solvents.

Frequently asked questions

Will the dashboard indicate a blown bulb?
It is possible: a LED unit draws too little current for the bulb controller. A load resistor on each side will eliminate the message.

Are these fog lights road-legal?
The manufacturer does not provide a European approval certificate. Check for an E-mark before using them on public roads.

Do I need to remove the bumper?
No, in most cases: access is through the wheel arch, with the wheel turned fully and the wheel arch liner spread.

What is the difference compared to a simple LED bulb?
Here, the entire unit is replaced, including the reflector and lens. This also corrects a yellowed or cracked lens, which a bulb alone cannot do.

Can I install only one?
Technically yes, but the tint of the new unit will clash with the old one. Replacing them as a pair is the only way to achieve a uniform look.

Give your Q7 a clean look again: two new units, built-in LEDs, fitted to the original mounting brackets.

Type: LED front fog light
Vehicle: Audi Q7 (2006-2009)
Contents: left and right pair
Source: Built-in LEDs
Voltage: 12 V
Lens: Clear PMMA
Installation: 30 to 45 minutes
Condition: 100% new