Baic Beijing BJ60 Window Deflectors: Ventilate Without Getting Wet
A window deflector is a rigid visor that mounts above the door frame and deflects airflow and raindrops. On the Baic Beijing BJ60 from 2022 onwards, this set allows you to drive with the windows slightly open by 2 to 3 cm in the rain, without spray entering the cabin or the resonant noise typical of an open window at constant speed. The kit is available in 4 pieces for the four doors, or 6 pieces with the quarter window deflectors.
Why Install Wind Deflectors on an SUV
- Car rain deflector: water slides over the visor and no longer enters through the upper opening.
- Less noise: the visor breaks up the vortex responsible for the dull thrumming above 60 km/h.
- Cooler cabin: it expels hot air from a vehicle left in the sun before you even start the air conditioning.
- Reduced condensation: a slight, continuous airflow limits condensation on the windows in cold weather.
- Two finishes: discreet solid black, or glossy trim that highlights the window frame.
- Two sizes: 4 pieces for the doors, 6 pieces to also cover the small rear windows.
Door Wind Deflector: The Situations That Make It Essential
In town under the rain, it allows air to filter through without wetting the door armrest. On the highway, it eliminates the hum of slightly open rear windows. During prolonged parking, it allows for light ventilation that lowers the interior temperature. For a smoker, it channels smoke outside. And with a dog on board, it ensures constant air renewal without a direct draft. On a large SUV like the BJ60, the glass surfaces are high: the effect on the interior temperature is particularly noticeable.
Technical Specifications
Material: tinted acrylic plastic injection-molded, UV-resistant. Tint: smoke black. Finishes: solid black or glossy trim on the edge. Contents: 4 pieces (2 front + 2 rear) or 6 pieces (2 front + 2 rear + 2 quarter windows). Stated compatibility: Baic Beijing BJ60, model year 2022 and later, to be checked according to the model before installation. Mounting: double-sided adhesive and frame clips depending on the version. Condition: 100% new.
Installation and Maintenance
Allow 20 to 30 minutes for a complete set, without drilling. Wash and degrease the window channel with alcohol, hold each visor in place to check its orientation, then remove the adhesive backing and press firmly from the center toward the ends. Do not close the window for 12 hours and wait 48 hours before using a high-pressure wash. Install in dry weather, above 15 degrees: below this threshold, the adhesive will not bond. Maintenance: soapy water and a soft cloth, never an abrasive product that would dull the acrylic.
Frequently Asked Questions
Do you need to drill to install a window deflector?
No. Installation is adhesive-based, supplemented by support in the window channel. No drilling is required.
Do the deflectors interfere with closing the window?
No, if they are installed in line with the window channel. Installing them too low can cause the window to rub: always hold them in place before gluing.
Can they go through an automatic car wash?
Yes, after 48 hours of curing. Avoid the most aggressive brushes during the first few weeks.
What is the difference between the 4-piece kit and the 6-piece kit?
The 4-piece kit covers the four doors. The 6-piece kit adds two visors for the small rear quarter windows, for a continuous line.
Is a window deflector allowed?
It is an exterior accessory that does not modify the lighting or the driver's field of vision. It must not protrude sideways or have sharp edges.
Are they resistant to frost and UV rays?
The tinted acrylic is UV-treated. In extreme cold, avoid scraping frost directly off the visor with a metal scraper.
Drive with the windows slightly open all year round: four visors, half an hour of installation, and the cabin breathes without taking in water.
Type: Side window deflectors
Compatibility: Baic Beijing BJ60 2022 and later, depending on the model
Contents: 4 or 6 pieces depending on the chosen version
Material: UV-resistant tinted acrylic
Tint: Smoke black
Finishes: Solid black or glossy trim
Mounting: Double-sided adhesive, no drilling
Installation: 20 to 30 minutes
Condition: 100% new
Customer reviews
Ordered this product from us? Leave a review and add your photos: it helps other enthusiasts choose.
- 30 daysto change your mind
- Legal warranty2-year conformity guarantee
- Expert advicereply within 24 business hours
