2-Inch Receiver Extension Hitch 445 mm

445 mm tow bar extension: gain the extra inches you need behind your car

There are situations where the original tow bar is too short: a cargo carrier that touches the tailgate, a trailer tongue that rubs the spare tire, or a caravan whose nose comes too close to the bumper. This 445 mm 2-inch receiver tube extension solves the problem in one piece: it extends the existing receiver by 9.65 inches and finally makes your existing tow bar usable.

A tow bar extension made from 2-inch square tubing

The body is made from 2-inch square tubing, the standard size for cargo carrier receivers. On the vehicle side, the extension slides in like any other accessory; on the trailer side, it provides a 2-inch opening ready to receive your ball, cargo carrier, or existing mount. A well-designed trailer tow bar extension is easy to spot: it doesn't require you to buy any other parts.

The black finish covers the steel along its entire length, including around the cross holes where water can seep in. The manufacturer CNSPEED states a towable load of 3000 kg GTW for a part weighing approximately 2.57 kg. A tow bar extension is still a part that works in cantilever: that is precisely why the 2-inch solid section and the thickness of the tubing matter more than appearance.

• 445 mm tow bar extension — 9.65 inches of extra clearance.
• 2-inch receiver tubing on both ends — compatible with your current accessories.
• 5/8 tow bar pin and clips included — nothing else to buy to lock the assembly in place.
• 3000 kg GTW stated — figure provided by the manufacturer CNSPEED.
• Full black finish — discreet behind the bumper, protective around the holes.
• Installation without special tools — slide it in, pin it, and clip it.

Installing the extension on your existing tow bar receiver

The procedure takes three steps: slide the extension into the vehicle's receiver tube, align the holes, insert the 5/8 pin, and attach the safety clip. Repeat the process at the other end with the accessory you want to extend. Installing a tow bar extension requires neither drilling nor welding. One point to check: make sure your receiver is a 2-inch size before ordering — check according to the version.

Does a tow bar extension reduce towing capacity?

Yes, mechanically. Lengthening the lever arm increases the stress on the vehicle's receiver: the usable capacity becomes that of the weakest link in the chain, never that of the strongest part. The common-sense rule for a 2-inch tow bar extension is to stay well below the stated values and to respect the tow load indicated on your car's manufacturer's plate. If in doubt, a towing professional will make the call in two minutes.

Your tow bar parts described with dimensions, not slogans

Length, section, pin diameter, stated load: for this type of part, only the dimensions matter. We use the tow bar specifications as published by the manufacturer, so you can compare them with your setup before confirming. The model listed here is the YC102642 from CNSPEED.

Measure the clearance you need and gain 44.5 cm behind your vehicle.

Type: Tow bar receiver tube extension / prolonger
Manufacturer and reference: CNSPEED, model YC102642
Length: 445 mm (9.65 inches)
Receiver section: 2-inch square tubing
Pin: 5/8 inch, with clips, included
Stated load: 3000 kg GTW
Weight: Approximately 2.57 kg
Stated package dimensions: 37 x 8 x 8
Finish: Black
Contents: 1 tow bar extension, 1 5/8 pin, clips
Compatibility: Vehicles equipped with a 2-inch receiver — check before installation