Sun Visor Clip Hyundai i20 Getz 2008-2015

Hyundai i20 and Getz sun visor clip: the small part that gets everything back in order

This grey sun visor clip is the replacement part that restores the hold of the interior sun visor in your Hyundai i20 or Getz produced between 2008 and 2015. It's always the same story: the plastic hook breaks, the sun visor falls down in front of the windshield at every speed bump, and you end up driving with an accessory dangling in your field of vision. For a few euros, part number 85235-05100 permanently solves the problem without having to replace the entire sun visor.

The original shape of the i20 hook reproduced identically

The rear plate, the clip tabs, and the rod receiving groove are copied from the original part: once in place, the Hyundai sun visor clip disappears into the headliner trim as if it had always been there. The grey shade matches the most common light interiors on these models, which avoids the unsightly colored patch above the windshield.

It's a repair that is immediately noticeable in daily use: the sun visor clicks again in the high position, holds to the side when you pivot it towards the side window, and no longer drops down on its own.

Reinforced molded plastic: why the original one gave out

The original hook breaks because it undergoes thousands of manipulations and especially severe thermal cycles — it is the area most exposed to the sun in the entire cabin. This replacement part is molded in a technical plastic with thickened ribs at the neck, exactly where the break occurs. Since it is an car interior sun visor used daily, this design detail makes the difference between a repair that holds and one that starts again in six months.

• Part number 85235-05100 — direct match with the factory-installed part, without adaptation.
• Restored hold in the high position — the sun visor no longer falls back into the field of vision at the first pothole.
• Light interior grey shade — it blends into the original headliner trim.
• Reinforced ribs at the neck — the area that breaks first on the original part has been thickened.
• Economical repair — a few euros instead of the complete replacement of the accessory.
• Installation in a few minutes — no heavy disassembly, no workshop intervention.

Replace the clip on your i20 or your Getz

Clear the debris from the old hook, unclip the plate using a plastic tool so as not to mark the roof lining, position the new part and press until the tabs click. This sun visor clip installation requires neither a specific screwdriver nor the removal of the entire trim. On some trims, a screw hidden under a cover holds the plate: check for the presence of this cover before forcing, the goal being to never pull on the headliner fabric.

Can you drive for a long time with a sun visor that no longer holds?

It is not recommended. A sun visor that falls down on its own enters the field of vision at the worst time, typically when approaching a curve or an intersection, and the reflex to push it back with one hand takes your attention away from the road. It is also a general appearance inspection point for resale: an interior where an accessory hangs immediately gives an impression of a neglected vehicle. Replacing the sun visor hook is one of the least expensive and most visible interventions you can do on a city car of this age.

Hyundai interior parts: the small references count too

We deliberately list these small parts that general catalogs ignore, because they condition the feeling of quality on board much more than we think. Searching for a sun visor clip for i20 should not take three hours and end with an uncertain used purchase. Our team answers in French if you want to confirm the reference on your vehicle.

Put your sun visor back in place: order the replacement clip part number 85235-05100.

Type: Interior sun visor mounting clip
Reference: 85235-05100
Compatible brand / model: Hyundai i20 and Hyundai Getz
Years: 2008 to 2015 — to be checked according to version
Position: Roof lining, above the windshield
Material: Molded technical plastic, reinforced ribs
Color: Light grey
Main function: Holding the sun visor in the high position
Installation: Clipping, without specific tool
Condition: 100% New